How to check the current and previous 30-day consumption on a Conlog meter

To request the current and previous 30 day consumption information from the meter, enter one of the below codes on the keypad.

For Average consumption: #271#

For Previous 24 hours : #272#
For Previous 30-days: #272##

• Related Articles

• How to check the current and previous 30-day consumption on a Landis & Gyr meter

  ​To request the current and previous 30 day consumption information from the meter, enter one of the below codes on the keypad. For Current consumption: i 008 For Previous 30-days: i 009

• Conlog Meter - beeping / alarm

  The Conlog Meters have an audible alarm (beeping) to warn you of low credit. To turn off this alarm using the meter keypad, press and hold the backspace (arrow) button for 3 seconds.

• Conlog Meter - Flashing Light Bulb

  Tamper mode is activated when the meter has been disconnected from power - this can be due to load shedding or if the meter was disconnected to be replaced or repaired. To reset the meter a Tamper Token must be entered. Please ask the STss Call ...

• Conlog Meter - What is my meter number?

  To view your meter number, enter #100# on your Conlog meter keypad. The meter number will be displayed.

• Conlog Meter - Determining the estimated time remaining on the meter at the current rate of electricity usage

  You can calculate how long you will have electricity based on the current rate of usage. This feature is useful to determine if there are sufficient units on the meter to last while you are away. e.g. At the current rate of usage, you will have ...